Rather than waiting any longer to have more time for write my bigger builds, I figured I should probably just get started on posting something and see where it goes.
Here it is, a shim for the Google Home. The basic goal was to create something that could increase the angle of the Google Home so that the status lights where clearer to see. Mine sits atop my standing desk making it difficult to see when seated. This raises the rear profile of the Google Home by 15mm.
I added a lip to the shim which fits the anti slip rubber on the base. The hole in the base is simply a time saving measure when printing, since there’s really no need to waste material supporting that area. If you wanted the grip back, you could add a couple of stick on rubber feet.
For anyone else who would like this, the links are below.